Home
Page |
 Lab
Series Filter SystemThis unit is designed for laboratory, prototype, and clean production operations in very small tanks. It is small enough to filter a half-gallon (2-L) beaker, yet powerful enough to use in tanks up to 5 or 10 gallons (19 to 38 L)--and sometimes larger-- depending on the application. The Lab Series provides a maximum flow rate of 400 gallons (1500 L) per hour, depending on the filter element and attachments selected. Use it stationary on one tank or move it from tank to tank. Multiple body lengths (2, 3, 4 and 6") enable use of the Lab Series in tanks with varying solution levels and depths. The Lab Series comes complete, preassembled, ready to operate and includes the items shown in the labeled photo (above). Three filter cartridges are provided to satisfy most filtration requirements. Two are the Magnum reusable style. One is a Poly-Wrap disposable cartridge. In addition, a simple-to-attach Filter Adapter included with the Lab Series enables the use of any standard 2.5"-diameter (6.35-cm) filter cartridge, including the popular high-quality Flo King Poly-Spun disposables. Lab Series Specifications Pump: Standard unit is made of polypropylene with Teflon-covered 303 stainless steel shaft. Pump also available on special-order basis in PVDF (Kynar), stainless steel, and CPVC. Titanium shaft also available. Call for pricing. Flow Rate: Up to 400 gallons (1500 liters) per hour at 60 Hz. A flow-rate reduction of about 18% is typical when operating at 50 Hz. Pressure: Very little head pressure. Not intended for solution transfer. Weight: About 3 pounds (1.3 kg) in polypro, depending on pump body length Motor: Specify one of the following motors when ordering: (1) 1/70th horsepower (11 watt), 115 V, 50/60 Hz, 2600/3000 RPM, 0.96 A (2) 1/70th horsepower (11 watt), 230 V, 50/60 Hz, 2600/3000 RPM, 0.48 A. Thermally Protected Important: To ensure priming and proper operation, solution must always be above Weep Hole on pump body. Specify length of pump body when ordering. (Note: Impeller is located just beneath Weep Hole and must be submerged in solution for pump to operate.) Lab Series Dimensions To determine the pump-body length, measure the "A" Dimension (from bottom of Motor Base, where pump is mounted on tank, to top of threaded Discharge Port, where solution is expelled from pump), as shown below:
|
Flo King Filter Systems, 401 Lake Bennett Ct., Longwood, FL
32750-6341 USA
Phone: 407-331-4634 Fax: 407-331-0575 E-Mail:
floking@sprintmail.com
"A" Dimension